Paradyne 4200 Uživatelský manuál stáhnout pdf (Strana 194)

10. Fault Commands

10-2

August 2002 4200-A2-GB20-00

RTRV-ALM-ADSL

The RTRV-ALM-ADSL command retrieves current alarms associated with an

ADSL facility on an LT.

Table 10-1. RTRV-ALM-ADSL Command Parameters

RTRV-ALM-ADSL:[tid]:aid_adsl:[ctag]::[ntfcde],,[srveff],[lo

cn],[dirn];

RESTRICTIONS: All parameters in this command are position-defined.

[tid] The identification of the target NE. TID is optional and has a default

value of null. The NE's SID code is the only other valid value.

aid_adsl Access identifier for the ADSL line(s). Enter in the following format,

replacing lower-case parameters with the values given:

ADSL-rack-shelf-slot-circuit

– rack: Rack Number (1)

– shelf: Shelf Number (1)

– slot: LT Slot Number (1)

– circuit: ADSL circuit on the LT (1−24) (ranging allowed)

Grouping and ranging are allowed. ALL may be used.

[ctag] The correlation tag that links an input command with its associated

output responses. It is assigned by the originator of the command. The

value is limited to six characters, which may be an identifier or a decimal

numeral. It is optional with a default of 0.

[ntfncde] Notification code. Valid values are:

CR: Critical alarm

MJ: Major alarm

MN: Minor alarm

Grouping is allowed. If no value is specified, ALL is assumed.

[serveff] Service effect. Valid values are:

SA: Service affecting

NSA: Not service affecting

Grouping is allowed. If no value is specified, ALL is assumed.

[locn] Location of the condition. Valid values are:

NEND: Near end

FEND: Far end

If no value is specified, ALL is assumed.

[dirn] Signal direction. The valid value is RCV (Receive ).

1 2 ... 189 190 191 192 193 194 195 196 197 198 199 ... 381 382

Žádné komentáře

Paradyne 4200 Uživatelský manuál Strana 194