Paradyne 4-Module Uživatelský manuál stáhnout pdf (Strana 9)

1.5.3 Establish a Power Connection

1.5.3.1 Connect Your Positive Power Lead to the Terminal Block

Using a Phillips Screwdriver, remove the upper screw from the chosen

terminal block (labeled "+" on the chassis). Slide the ring terminal of your

positive power lead around the shaft of the screw and re-insert the screw

into the same "+" terminal from which it was removed.

1.5.3.2 Connect Your Negative Power Lead to the Terminal Block

Remove the right-hand screw (labeled "-") from the same terminal block.

Slide the ring terminal of your NEGATIVE lead around the shaft of the screw

and re-insert the screw into the same "-" terminal from which it was

removed.

DC Terminal Blocks

DC POWER SPECIFICATIONS

-48V DC

10 Amps maximum

Although actual power draw depends upon

chassis configuration, a fully loaded chassis

averages around 6 Amps.

Ring

Terminal







POSITIVE

POWER LEAD

DC POWER

TERMINAL

Positive (+)

Terminal

 

Page 9 of 17IPD4000E Installation Instructions 220-0000097 rev01

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17

Žádné komentáře

Paradyne 4-Module Uživatelský manuál Strana 9