Paradyne 24-Port SHDSL Mini DSLAM SMD2000-24T Uživatelský manuál stáhnout pdf (Strana 10)

The two terminal blocks on the SMD2000-24T are independent feeds. Chassis

power is supplied by only one terminal block at a time; the second supply is merely

backup. Likewise, the two terminal blocks do not load-share. Each terminal block

must be supplied with the adequate amperage to run the chassis.

4. Using a Phillips screwdriver, remove the left screw from the chosen terminal block

(labeled "+" on the chassis). Slide the ring terminal of your positive power lead onto

the shaft of the screw and re-insert the screw into the terminal block (same "+"

terminal from which it was removed).

5. Remove the right-hand screw (labeled "–") from the same terminal block, slide the

ring terminal of your negative lead onto the shaft of the screw and re-insert the

screw into the terminal block (same "–" terminal from which it was removed).

CAUTION:

Be sure to attach the positive lead to the positive terminal and the nagative

lead to the negative terminal as indicated on your SMD2000-24T terminal

block labels.

6. Attach the other ends of the power leads to a fuse panel. The negative (–) lead

connects to a "Batt" (Battery) terminal and the positive (+) lead connects to a

"Return" terminal on your DC power supply.

Positive (Return) Lead

Negative (Batt) Lead

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Žádné komentáře

Paradyne 24-Port SHDSL Mini DSLAM SMD2000-24T Uživatelský manuál Strana 10